Accumulator Repair Guide

Accumulator Repair Guide
When a novice is repairing the accumulator, it is necessary to check if all the accessories in the accumulator are in a normal state. If everything is normal, then start the power supply of the accumulator and set a good voltage value. Then check the gas in the bladder once a week. After the month, the inspection time is stipulated in a month or so, that is, the gas in the accumulator is checked every other month, and the inspection period is changed after six months. It is not until one year later that the accumulator can be maintained. The time is set to check once a year. When checking, connect the oil inlet in the accumulator to the oil circuit of the fuel tank. Then open the valve and set the value of the pressure meter. Start the power supply of the valve and the oil will follow the machine. The flow runs to the tank and at the same time controls the index of the pressure meter. When the machine starts to run, the pressure pointer will slowly decrease. After falling to a certain value, it will quickly return to zero. When the machine runs for a while, the meter will The index will rise, because the gas in the pressure meter will be lost during the inspection, so the temperature of the meter is slower, but this does not affect the operation of the accumulator, so the glass reactor The manufacturer recommends that everyone, as long as the proper operation of the accumulator will extend its useful life.

The above:How to repair gear pump parts?